Suggested Applications

The following are recommended substrates to coat:

ACCEPTABLE APPLICATIONS

• Metal - Coated or Galvanized Steel Weathered Aluminum
• Weathered Copper
• EPDM Rubber membrane
• Concrete (except foot traffic surfaces)
• Urethane Foam
• Primed Wood
• Fiberglass
• PVC Sheet and Pipe
• Acrylic Sheet
• Sponge Rubber insulation
• EPDM Rubber Membrane on flat or sloped Roofs
• Weathered Steel Siding
• Weathered Fiberglass
• Weathered standing seam and corrugated metal roofs
• Weathered Vinyl, PVC and Polycarbonate plastic
• Foam insulation for pipe
• Cast Concrete foundations

For Neoprene:

If Neoprene rubber has been Talced then this should be removed by washing with detergent or wiping with solvent soaked rag. Liquid Rubber can be applied directly to Neoprene. Some swelling of the Neoprene should be expected but this will recover over time. The distortion resulting from the swelling will be greater if Neoprene is thin and not adhered to a rigid substrate.

For Polyurethane:

A light sanding of the surface is recommended for better adhesion. No swelling will occur.

UNACCEPTABLE APPLICATIONS

Do Not use Liquid Roof or Liquid Rubber on the following substrates: For the below applications you can use the asphalt based system located here Asphalt Based Repairs

• Built up asphalt roofs
• Asphalt shingles
• Modified asphalt roll roofing
• Trafficked areas such as decks or patios
• Stainless steel Glass Silicone caulk Foot traffic surfaces Hypalon Membrane

 Facebook       Twitter       YouTube